Monash University: University Handbooks: Undergraduate handbook 2005: Units indexed by faculty
Previous page | Next page | Section contents | Title and contents

Undergraduate handbook 2005 - Engineering

Degree programs

Caulfield
Clayton
Single degrees
Double degrees

* Levels 2 and 3 of this program will be offered on the Clayton campus from 2005. Level 4 will be offered on the Caulfield campus in 2005. From 2006, the entire program will be offered on the Clayton campus.

Gippsland
Malaysia

Duration of degrees

Pass

With the exception of the two Bachelor of Technology degrees, all the single undergraduate degree programs listed above are of four years duration if taken full-time or up to eight years duration if taken part-time. The Bachelor of Technology degrees are of three years duration (two years at Monash University) if taken full-time and up to five years (at Monash) duration if taken part-time. The double degrees are of either five or six years duration if taken full-time, with some overloading.

Honours

A candidate is awarded a degree with honours for meritorious performance throughout the course in engineering programs offered by the faculty. No additional time is required. All units which have a numerical mark are considered in the determination of an honours result for single degrees, but greater weight is given to the units in the later years of the course than to those in the earlier years. Honours for the engineering component of double degrees is calculated on the engineering units only. The two Bachelor of Technology degrees do not have honours.

Previous page | Next page | Section contents | Title and contents