DipEng (Industrial Management)
Level
2A technical elective may be substituted if a Year 12 mathematics subject has
been passed.
Subject
Credit
points
Prerequisites
Corequisites
The
course consists of five modules from which a student must pass modules 1, 2 and
5 and either module 3 or 4. Students should normally complete modules 1 and 2
first before doing other modules. Subjects from several modules may be studied
at the same time. Not all subjects are offered each year. See Faculty of
Business handbook for descriptions of business electives.
Module
1: Introduction to management
GEG5004
Industrial management
6
GEG5012
GEG5012
Human communications
3
GEG6114
Safety management
6
GBU7001
Managing for productivity
6
GCO1831
Introduction to computers
3
Module
2: Industrial management
GEG6004
Industrial management methods
6
GCO1831
or permission
GEG6124
Engineering project supervision
6
GEG6904
Production and operations management
6
Completion
of all level-1 subjects or permission
GBU7004
Human resource practices
6
Module
3: Maintenance management
GEG5634
Maintenance engineering
6
GEG6054
Machine condition monitoring
6
GEG6634
Maintenance management
6
GBU7006
Financial management
6
or
Module
4: Technical module
GAS1080
Physical science1
6
GAS1601
Basic mathematics2
6
Assumes
Maths to Year 11
Technical
electives (minimum 12 credit points)
12
Module
5: Industrial experience
GEG6044
Industrial project
6
Completion
of modules 1 and 2 or permission
GEG6058
Industrial experience
12
Elective
(from management or technical electives - minimum 6 credit points)
6
1A
technical elective may be substituted if a Year 12 science subject has been
passed.
Note
1
Students seeking articulation to the Bachelor of Engineering are advised to
take module 4.
2
Credit for subjects may be given for previous equivalent studies.
Electives
Management
GBU1201
Introduction to business law
6
GBU3314
Training and development
6
GBU7014
Marketing
6
and
other business subjects offered by the Gippsland School of Business and
approved by the head of the Gippsland School of Engineering for use as
electives.
Technical
GEG5124
Drawing and design
Approved
subjects from level 1 or level 2 of the Bachelor of Engineering or Bachelor of
Engineering Studies courses, if prerequisites are met.
Further
information may be obtained from the course coordinator, Mr Kevin Cale.
| Published by Monash University, Clayton, Victoria
3168 Copyright © Monash University 1996 - All Rights Reserved - Caution Authorised by the Academic Registrar December 1996 |