Level

Subject

Credit points

Prerequisites

Corequisites

Diploma of Engineering (Industrial Management)

(available at Gippsland campus only)

The course consists of five modules from which a student must pass modules 1, 2 and 5 and either module 3 or 4. Students should normally complete modules 1 and 2 before doing other modules. Subjects from several modules may be studied at the same time. Not all subjects are offered each year. See the Business and Economics section for descriptions of business electives.

Module 1: Introduction to management

GEG5004 Industrial management

6

GEG6114 Safety management

6

Business subject

6

GCO1851 Computers in systems and applications

6

Module 2: Industrial management

GEG6004 Industrial management methods

6

GCO1851 or permission

GEG6124 Engineering project supervision

6

GEG6904 Production and operations management

6

Completion of all level 1 subjects or permission

Business subject

6

Module 3: Maintenance management

GEG5634 Maintenance engineering

6

GEG6054 Machine condition monitoring

6

GEG6634 Maintenance management

6

Business subject

6

Or

Module 4: Technical module

ACS1609 Basic physical science¹

6

MAT1049 Basic mathematics²

6

Assumes mathematics to Year 11

Technical electives (minimum 12 credit points)

12

Module 5: Industrial experience

GEG6044 Industrial project

6

Completion of modules 1 and 2 or permission

GEG6058 Industrial experience

12

Elective (from management or technical electives -- minimum 6 credit points)

6

¹ A technical elective may be substituted if a Year 12 science subject has been passed.
² A technical elective may be substituted if a Year 12 mathematics subject has been passed.

Notes
1. Students seeking articulation to the Bachelor of Engineering are advised to take module 4.
2. Credit for subjects may be given for previous equivalent studies.

Electives

Management

Business subjects offered by the Gippsland School of Business and approved by the head of the Gippsland School of Engineering for use as electives

Technical

GEG5124 Drawing and design

6

Approved subjects from level 1 or level 2 of the Bachelor of Engineering, if prerequisites are met.

Further information may be obtained from the course coordinator, Mr Ray Beebe.