Monash University Engineering handbook 1995

Subject list IV

The course consists of five modules from which a student must pass modules 1, 2 and 5 and either module 3 or 4. Students should normally complete modules 1 and 2 first before doing other modules. Subjects from several modules may be studied at the same time. Not all subjects are offered each year.

Module 1: Basic supervision

GEG5004 Industrial supervision CP 6; P GEG5012; C -

GEG5012 Human communications CP 3; P -; C -

GEG6114 Safety management CP 6; P -; C -

GBU7001 Productivity improvement 1 CP 6; P -; C -

GCO1831 Introduction to computers CP 3; P -; C -

Module 2: Industrial supervision

GEG6004 Industrial management methods CP 6; P GCO1831 or permission; C -

GEG6124 Engineering project supervisionCP 6; P -; C -

GEG6904 Production and operations management CP 6; P Completion of all level-1 subjects or permission; C -

GBU7004 Human resource management CP 6; P -; C -

Module 3: Maintenance supervision

GEG5124 Drawing and designCP 6; P -; C -

GEG5634 Plant engineering CP 6; P -; C -

GEG6634 Maintenance supervision CP 6; P -; C -

GBU7006 Financial management CP 6; P -; C -

or

Module 4: Technical module

GAS1080 Physical science^{1 CP 6; P -; C -}

GAS1601 Basic mathematics^{2 CP 6; P Assumes maths to Year 11}

Technical electives (minimum 12 credit points)

Module 5: Industrial experience

GEG6044 Industrial project CP 6; P Completion of modules 1 and 2 or permission; C -

GEG6058 Industrial experience CP 12; P -; C -

Elective (from supervision or technical electives - minimum 6 credit points)

^{1A technical elective may be substituted if a Year 12 science subject has been passed.}

^{2A technical elective may be substituted if a Year 12 mathematics subject has been passed.}

Note

1.Students seeking articulation to the Bachelor of Engineering are advised to take module 4.

2.Credit for subjects may be given for previous equivalent studies.

Electives

Supervision

GBU1201 Introduction to business law CP 6; P -; C -

GBU3314 Training and development CP 6; P GBU1302; C -

Technical

GEG5124 Drawing and design CP 6; P -; C -

Approved subjects from level 1 or level 2 of the Bachelor of Engineering courses.

Further information may be obtained from the course coordinator, Mr Keith Enders.